This is a helpful OSAT project because it will help anyone in the developing world keep any toilet paper off the ground where it could potentially get wet or dirty therefore this is a more sanitary and will waste less toilet paper.
Technical Specifications and Assembly Instructions
Assemble the spring into the larger tube and then insert the smaller tube into the large tube making sure it slides freely but locks in with the small groove on the inside of the large tube. Make sure the two tubes slide freely then and rotate in the holders. Then Place the holders in the desired location Mark screw holes and then attach to the wall.
Print time estimate: 10 Hours
Assembly time estimate: 10 minutes
Including drawings or pictures of the device at stage of assembly at minimum.
Common Problems and Solutions
Common problems: if you don't want to use support material make sure the tubes appear to be upright in the slicer otherwise they will not of as high of quality if they are laid flat.
Cost savings
$1-3 in plastic $1 Spring
Find a commercial equivalent, cite it and put the [1]
Total Savings of about $10 over commercial equivalent.
Benefited Internet Communities
Name and add links to at least 5 using single brackets around [url name]
References
No references were used.
Based on the developmental needs addressed (e.g. food, heat, electricity, clean water, health care, etc.) be sure to label your device in the proper categories e.g. use . Be sure to categorize your device so that it will be easy to find – for example “Low voltage connection basics” is categorized in
